Installation guide

82
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Command Reference
debug radio
Use the command debug radio ? to display a list of all available debug commands.
Use the no version of the command to stop the process.
Use the show debug command to display the current debug settings.
debug radio {lm_log | messages | phy}
no debug radio
show debug
Syntax Description
totalGain 2 0.5 dB dB X/2
gainSettingIF 2 0.5 dB dB X/2
gainSettingRF 2 2
(-16)
dB dB X/2
16
in 1 SINR = 10*log10(x/2
16
) + 9 SINR in dB 10 * log10(2
16
/X) + 9
in 2 SINR = 10*log10(x/2
16
) + 9 SINR in dB 10 * log10(2
16
/X) + 9
inr log2 (Ratio) In ratio in dB 10 * log10(2
x
)
byteErrors Number of errors Same Same
Table 15 Value Conversions (continued)
Parameter Units Reported (X) Units Conversion Formula
lm_log log [verbose]
phy {radioLog | cwrLog}
radioLog radio slot/port subModule
slot Positive integer representing the Cisco uBR7200 series slot number.
port Positive integer representing the port number on that slot.
subModule {cli | gal | snmp} logLevel
cli Tracing for radio interface CLI commands.
gal Tracing for the gate-array logic (GAL) module.
snmp Tracing for the radio Simple Network Management Protocol (SNMP) module.
logLevel Acceptable values are: {all | controlFlow | dataFlow | validation | verbose}
cwrLog cwrLog modName
modName Name of the module