Installation guide

73
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Command Reference
show controllers radio
Use this command in privileged EXEC mode to display all or a subset of attributes of a particular modem
card. If none of the options are specified, all the hardware subsystem(s) information will be displayed.
Actual output parameters depend on the hardware and implementation.
show controllers radio slot number/port number [{if | rf | fir | codec | dsp | arq | pci | phy | driver}]
Syntax Description
Note Entering the command show controllers slot/port rf will display electrically erasable programmable
read-only memory (EEPROM) values and report if the wireless transverter is not detected.
Example
The following example shows the output received when the pci option is specified for the modem card
in slot number 3, port number 0.
UBR04# show controllers radio 3/0 pci
Interface Radio 3/0
Hardware is CWRP2P
throttled 0 enabled 0 disabled 0
Rx: spurious 0 framing_err 0 no_buffer 0, pause_no_err_ints 0
no_enqueue 0 no_stp 0 no_enp 0
Tx: full 0 drop 0
rx ring entries 32 tx ring entries 128
Rx ring 0x4B05A0C0 shadow 0x61399C60 head 2
Normal Latency Tx ring 0x4B05A680 shadow 0x6139A1C0 head 0 tail 0 count 0
Low Latency Tx ring 0x4B05A220 shadow 0x61399D50 head 3 tail 3 count 0
PCI Configuration Registers
Device/Vendor IDs - 0x00141137
Command/Status - 0x02000086
Latency Timer - 0x0000FF00
Base Address 0 - 0x4E000000
Max Lat - 0x000001FF
PCI Interface FPGA
dmac_control - 0x00440002
dmac_status - 0x00004000
dmac_int_status - 0x99800001
dmac_int_enable - 0x66710FF8
dmac_tx0_ring_base - 0x4B05A220
dmac_tx1_ring_base - 0x4B05A680
dmac_rx_ring_base - 0x4B05A0C0
dmac_configuration - 0x66040303
local_bus_error_status - 0x00000000
local_bus_error_address - 0x010C0000
local_bus_reset - 0x00000000
fpga_configuration_control - 0x00000000
fpga_configuration_status - 0x000000FF
slot number Positive integer representing the Cisco uBR7200 series slot number.
port number Positive integer representing the port number on that slot.