Installation guide
Table Of Contents
- CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation an...
- If You Need More Information
- Wireless Modem Card and Subsystem Overview
- Field-Replaceable Units
- Installation Prerequisites
- Removing and Installing the Wireless Modem Card
- Installing the Power Feed Panel
- Configuring a Wireless Modem Card
- Command Reference
- Syntax Conventions
- Startup Commands
- Installation and Configuration Commands
- Operating Commands
- Monitoring the System
- Troubleshooting
- show controllers radio
- radio histogram
- radio byteErrorHist
- show interfaces radio (histspec)
- show interfaces radio (histdata)
- debug radio
- Images and Image Repositories
- radio image-add
- radio image-move
- show interfaces radio (imagehdr)
- show radio repository
- radio snapshot
- radio scope-output
- radio timeline
- show interfaces radio (tlspec)
- show interfaces radio (tldata)
- Regulatory Compliance and Safety Information
- FCC Registration and Requirements
- Translated Safety Warnings
- Short-Circuit Protection Warning
- Disconnect Device Warning
- Lightning Activity Warning
- Installation Warning
- Jewelry Removal Warning
- Supply Circuit Warning
- Service Personnel Warning
- Product Disposal Warning
- Faceplates and Cover Panel Requirement
- Chassis—Rack-Mounting and Servicing Warning
- Restricted Area Warning
- Earthed Conductor Warning
- Power Cabling Warning
- Ground Connection Warning
- Power Supply Wiring Warning
- Copper Conductors Warning
- Exposed DC Power Wire Warning
- 48 VDC Power System Warning
- SELV-IEC 60950 DC Power Supply Warning
- DC Power Disconnection Warning
- DC Input Wiring Warning
- Ground Wire Connection Warning
- Ground Conductor Warning
- No. 26 AWG Wire Warning
- Coaxial Cable Specification Warning
- Transverter Location Warning
- Obtaining Documentation
- Obtaining Technical Assistance
72
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Command Reference
clear radio interface radio link-metrics
Use this command in privileged EXEC mode to clear all physical layer metrics associated with the radio
interface.
clear radio interface radio slot/port link-metrics
Note To keep physical layer and protocol layer statistics consistent, Cisco recommends that a clear
interface radio slot/port command be entered to also clear the protocol layer statistics.
Syntax Description
Example
The following command clears all radio link-metrics details:
UBR04 # clear radio interface radio 6/0 link-metrics
Troubleshooting
These commands normally are used only by technical support personnel to gain the information needed
to troubleshoot a system:
• show controllers radio—To display attributes of a wireless modem card
• radio histogram—To configure a histogram collection specification
• radio byteErrorHist—To set the histogram collection interval for uncorrected codewords
• show interfaces radio (histspec)—To display the details of the histogram specifications
• show interfaces radio (histdata)—To display the collected histogram data
• debug radio—To set debug commands and display current debug settings
• radio image-add—To add a specified image to the image repository
• radio image-move—To move a specified image to the beginning of the repository list
• show interfaces radio (imagehdr)—To display details of the images to be downloaded
• show radio repository—To display the protocol-specific list of images in the repository
• radio snapshot—To capture a specified amount of data from the wireless modem card
• radio scope-output—To configure a DSP to send an identified type of output to the serial port for
analysis
• radio timeline—To collect a sequence of data values for a specified attribute
• show interfaces radio (tlspec)—To display timeline specifications
• show interfaces radio (tldata)—To display timeline data
slot Positive integer representing the Cisco uBR7200 series slot number.
port Positive integer representing the port number on that slot.