Installation guide
Table Of Contents
- CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation an...
- If You Need More Information
- Wireless Modem Card and Subsystem Overview
- Field-Replaceable Units
- Installation Prerequisites
- Removing and Installing the Wireless Modem Card
- Installing the Power Feed Panel
- Configuring a Wireless Modem Card
- Command Reference
- Syntax Conventions
- Startup Commands
- Installation and Configuration Commands
- Operating Commands
- Monitoring the System
- Troubleshooting
- show controllers radio
- radio histogram
- radio byteErrorHist
- show interfaces radio (histspec)
- show interfaces radio (histdata)
- debug radio
- Images and Image Repositories
- radio image-add
- radio image-move
- show interfaces radio (imagehdr)
- show radio repository
- radio snapshot
- radio scope-output
- radio timeline
- show interfaces radio (tlspec)
- show interfaces radio (tldata)
- Regulatory Compliance and Safety Information
- FCC Registration and Requirements
- Translated Safety Warnings
- Short-Circuit Protection Warning
- Disconnect Device Warning
- Lightning Activity Warning
- Installation Warning
- Jewelry Removal Warning
- Supply Circuit Warning
- Service Personnel Warning
- Product Disposal Warning
- Faceplates and Cover Panel Requirement
- Chassis—Rack-Mounting and Servicing Warning
- Restricted Area Warning
- Earthed Conductor Warning
- Power Cabling Warning
- Ground Connection Warning
- Power Supply Wiring Warning
- Copper Conductors Warning
- Exposed DC Power Wire Warning
- 48 VDC Power System Warning
- SELV-IEC 60950 DC Power Supply Warning
- DC Power Disconnection Warning
- DC Input Wiring Warning
- Ground Wire Connection Warning
- Ground Conductor Warning
- No. 26 AWG Wire Warning
- Coaxial Cable Specification Warning
- Transverter Location Warning
- Obtaining Documentation
- Obtaining Technical Assistance
67
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Command Reference
Example
The following command will display the link metrics for the wireless modem card in slot 6, port 0 of the
Cisco uBR7200 series router:
UBR04# show interfaces radio 6/0 link-metrics
Link Metrics since the router was reloaded:
Availability of the physical link:
Link available for: 00:25:11
Link unavailable for: 00:00:15
Link availability percent: 99.2
Link was not synchronized for: 00:00:14
Time since last successful synchronization: 00:25:12
Synchronization failure count: Represents the SyncFailureCount—Number of failed
synchronization attempts.
Synchronization loss count: Represents the number of times the radio link was
synchronized, but lost synchronization with the remote end
without intervention.
Managed synchronization loss count: Represents ManagedSyncLoss—Number of
synchronization losses initiated by the operator or the
network (IP layer) during the seconds the link was up.
Synchronization Recovery Counters
High effort resynchronization count: Represents the SyncLossCount (high effort)—Number of
times that the high-effort resynchronization procedure was
performed.
Medium effort resynchronization count: Represents the SyncLossCount (medium effort)—Number
of times that the medium-effort resynchronization
procedure was performed.
Low effort resynchronization count: Represents the SyncLossCount (low effort)—Number of
times that the low-effort resynchronization procedure was
performed.
Physical Link Data Rates
Effective rate: Represents the effective data throughput while the link was
synchronized. For a given bandwidth and throughput
selection, it represents the data throughput being achieved.
Note If ARQ is turned on, or there are errors due to
propagation conditions, this number may be less
than the expected total throughput.
Percent efficiency: Represents the ratio of total good codewords received to the
total number of codewords received, stated as a percentage.