Installation guide
Table Of Contents
- CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation an...
- If You Need More Information
- Wireless Modem Card and Subsystem Overview
- Field-Replaceable Units
- Installation Prerequisites
- Removing and Installing the Wireless Modem Card
- Installing the Power Feed Panel
- Configuring a Wireless Modem Card
- Command Reference
- Syntax Conventions
- Startup Commands
- Installation and Configuration Commands
- Operating Commands
- Monitoring the System
- Troubleshooting
- show controllers radio
- radio histogram
- radio byteErrorHist
- show interfaces radio (histspec)
- show interfaces radio (histdata)
- debug radio
- Images and Image Repositories
- radio image-add
- radio image-move
- show interfaces radio (imagehdr)
- show radio repository
- radio snapshot
- radio scope-output
- radio timeline
- show interfaces radio (tlspec)
- show interfaces radio (tldata)
- Regulatory Compliance and Safety Information
- FCC Registration and Requirements
- Translated Safety Warnings
- Short-Circuit Protection Warning
- Disconnect Device Warning
- Lightning Activity Warning
- Installation Warning
- Jewelry Removal Warning
- Supply Circuit Warning
- Service Personnel Warning
- Product Disposal Warning
- Faceplates and Cover Panel Requirement
- Chassis—Rack-Mounting and Servicing Warning
- Restricted Area Warning
- Earthed Conductor Warning
- Power Cabling Warning
- Ground Connection Warning
- Power Supply Wiring Warning
- Copper Conductors Warning
- Exposed DC Power Wire Warning
- 48 VDC Power System Warning
- SELV-IEC 60950 DC Power Supply Warning
- DC Power Disconnection Warning
- DC Input Wiring Warning
- Ground Wire Connection Warning
- Ground Conductor Warning
- No. 26 AWG Wire Warning
- Coaxial Cable Specification Warning
- Transverter Location Warning
- Obtaining Documentation
- Obtaining Technical Assistance
66
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Command Reference
Display Elements
When linkMetrics are requested, the following values are displayed:
Availability of the Physical Link
Link available for: Represents AvailableSeconds—Number of seconds (while
the link was up) during which the link was available for data
transmission (Error Free Seconds + Errored Seconds –
Severely Errored Seconds).
Link unavailable for: Represents UnAvailableSeconds—Number of seconds
(while the link was up) during which the link was not
available for data transmission (Severely Errored Seconds +
SyncLossSeconds).
Link availability percent: Represents the ratio of the AvailableSeconds to the seconds
the link was up, stated as a percentage.
Link was not synchronized for: Represents SyncLossSeconds—Number of seconds (while
the link was up) that were spent with the link out of
synchronization.
Time since last successful
synchronization:
Represents the elapsed time since the radio link successfully
synchronized with the remote end.
Time since last synchronization failure: Represents the elapsed time since the radio lost
synchronization with the remote end.
Error Characteristics of the Physical Link
Percent error free seconds: Represents the ratio of cumulative Codeword Error Free
Seconds (EFS) to the seconds the link was up, stated as a
percentage.
Percent errored seconds: Represents the ratio of cumulative Codeword Errored
Seconds (CES) to the seconds the link was up, stated as a
percentage.
Percent severely errored seconds: Represents the ratio of cumulative Codeword Severely
Errored Seconds (SES) to the seconds the link was up, stated
as a percentage.
Percent degraded minutes: Represents the ratio of Codeword Degraded Minutes (DM)
to the seconds the link was up, stated as a percentage.
Synchronization Event Counters
Synchronization success count: Represents the SyncSuccessCount—Number of successful
synchronization attempts.