Installation guide

64
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Command Reference
Example
The following command sequence will set up a threshold for totalGain. When the totalGain for the
system on antenna2 falls below 70, the eventSet event type will be generated.
UBR04(config-if)# radio threshold totalGain 2 lowThreshold 70
show interfaces radio (thresholds)
Use this command in privileged EXEC mode to display the set of currently configured thresholds on the
modem card on the specified digital signal processor (DSP). If dspNum is not specified, the thresholds
for DSP 3 will be displayed.
show interfaces radio slot/port thresholds [dspNum]
Syntax Description
Example
The following command will display the set of currently configured thresholds for the modem card in
slot 6, port 0 for the Receive DSP 1b:
UBR04# show interfaces radio 6/0 thresholds dsp dsprx1b
Threshold Attributein
Threshold TypedownChange
Antenna Id2
Threshold Value200
Threshold Repeat Time5
Threshold Clear Time8
Threshold DSP Numberdsprx1b
Index2
Default Thresholdfalse
show interfaces radio (link-metrics)
Use this command in privileged EXEC mode to display the parameters measured during the operation
(and in some cases, nonoperation) of the radio link. These metrics provide a quantitative measure of how
well the radio link is performing over time.
There are two classes of link metrics:
• Metrics that quantify how the link performed since the system was powered on:
show interface radio slot/port link-metrics
• Metrics that quantify how the link performed while the two ends of the link were synchronized:
show interface radio slot/port 24hour-metrics
(details for the last 32 days)
show interface radio slot/port radio 1hour-metrics 1Hr_options
slot Positive integer representing the Cisco uBR7200 series slot number.
port Positive integer representing the port number on that slot.
dspNum The DSP number.