Installation guide

62
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Command Reference
Note When changing from 12 MHz to 6 MHz mode, the DSP on which the parameter is defined may no
longer be valid. If so, redefine the threshold on a DSP where the parameter is meaningful.
Syntax Description
Table 13 Statistical Parameters and Meaningful DSPs
Statistical Parameter
Antenna-Specific
Parameter
Data Meaningful on
DSP (12 MHz)
Data Meaningful on
DSP (6 MHz)
Received Power Yes rx3b rx2b
Gain Settings IF Yes rx3b rx2b
Gain Settings RF Yes rx3b rx2b
Total Gain Yes rx3b rx2b
Interference + Noise Dual Antenna
Required
Any rx DSP rx1a, rx1b, rx2a, rx2b
Interference + Noise
Ratio
Dual Antenna
Required
Any rx DSP rx1a, rx1b, rx2a, rx2b
Constellation Variance No Any rx DSP rx1a, rx1b, rx2a, rx2b
Sync Status No rx3b rx2b
Timing Offset No rx3b rx2b
Frequency Offset No rx3b rx2b
threshParam {in | inr | constVariance | timingOffset | freqOffset | syncStatus | receivedPower |
gainSettingsIF | gainSettingsRF | totalGain}
in (Interference + Noise) The interference plus noise power levels are computed by
the hardware on a burst-by-burst basis.
Note This parameter is available for a dual antenna system only.
inr (Interference + Noise Ratio) The ratio of the interference plus noise power levels
captured by the first antenna to the second antenna on a burst-by-burst basis. This
value is specified as a log to base 2 number.
constVariance (Constellation Variance) The average energy of the constellation error signal – the
error between the received (noisy) constellation symbol and the nearest ideal
constellation symbol. Constellation Variance is a measure of the Signal to
Interference plus Noise ratio (SINR) for that tone. On a single antenna system, it
represents (SINR)
-1
. On a dual antenna system, it represents a composite value
providing (SINR)
-1
after antenna combining.
timingOffset Represents the timing delay variations detected in the radio link.