Installation guide

5
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Wireless Modem Card and Subsystem Overview
Figure 4 Wireless Modem Card Connectors and LEDs
Table 1 Wireless Modem Card Connectors
Connector Type Input/Output Function
Control—Main 8-pin RJ-45 (female) Output Physical connection to Power Feed
Panel for RF subsystem interface
control channel (main antenna).
Control—Diversity 8-pin RJ-45 (female) Output Physical connection to Power Feed
Panel for RF subsystem interface
control channel (diversity antenna
when diversity option is used).
10-MHz Input SMA (female) Input Connection for optional 10-MHz
external reference clock.
Note If you require greater frequency
accuracy, an external clock can
be attached to the wireless
modem card designated as
“master.” (For a list of
accessory suppliers, refer to the
Cisco Broadband Fixed
Wireless Site Planning Guide.)
Diversity — Monitor SMA (female) Output For connection to spectrum analyzer
for test/troubleshooting purposes
(when diversity option is used).
Note The monitor output level is the
same as that of the power feed
panel.
Diversity —PFP SMA (female) Output 24-MHz reference, receive and
transmit IF signals (when diversity
option is used).
24257
DIVERSITY
CONTROL
10MHz
IN
MONITOR
DIVERSITY
MAIN
PFP
MONITOR
uBR-MCW-PDA
CARRIER
OUT OF SERVICE
MINOR ALARM
MAJOR ALARM
PFP
MAIN
ENABLED
DIVERSITY
CONTROL
MAIN
10MHz
IN
MONITOR
DIVERSITY
MAIN
PFP
MONITOR
PFP
CARRIER
OUT OF SERVICE
MINOR ALARM
MAJOR ALARM
ENABLED
Debug port