Installation guide

37
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Command Reference
• Operating Commands—Used during normal operation to configure baseline encryption, duplexer
characteristics, LEDs, and Automatic Response Query (ARQ) settings:
– radio privacy
– radio duplexor
– radio led
– radio arq
– show interfaces radio (arq)
• Monitoring the System—Used during operation to monitor the system’s actions and set
measurements of system statistics:
– radio metrics-threshold
– radio threshold
– show interfaces radio (thresholds)
– show interfaces radio (link-metrics)
– clear radio interface radio (link-metrics)
• Troubleshooting—Used normally only by technical support personnel to manipulate microcode
images and capture troubleshooting information:
– show controllers radio
– radio histogram
– radio byteErrorHist
– show interfaces radio (histspec)
– show interfaces radio (histdata)
– debug radio
– radio image-add
– radio image-move
– show interfaces radio (imagehdr)
– show radio repository
– radio snapshot
– radio scope-output
– radio timeline
– show interfaces radio (tlspec)
– show interfaces radio (tldata)
Caution To save your configuration in case of power off or software reload, enter the
copy running-configuration startup-configuration command at the routername# prompt both
during and at the end of your configuration tasks.
Note To see a list of the configuration commands available to you, enter ? at the prompt or type help while
in configuration mode.