Installation guide

29
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Installing the Power Feed Panel
Figure 26 Connecting the IF Cable (from the Wireless Modem Card)
If you will be using the diversity feature, also connect the cable coming from the Diversity/PFP port of
the modem card to the Diversity/MC port on the power feed panel.
Connecting the IF Cable (to the Wireless Transverter)
Attach one end of the IF cable to the Main-ODU/Output connector. (See Figure 27.) If stiff coaxial cable
is being used for the connection, first attach a “pigtail” adapter using flexible coaxial cable.
Warning Use50-ohmcoaxial cable with a center conductor size of 10 AWGor larger (for example, LMR-400,
3/8-inch FSJ Superflex Heliax, or larger). Failure to do so can result in overheating, fire, or
long-term failure. Localand nationalelectrical codesmust beobserved. To see translationsof the
warnings that appear in this publication, refer to the “Regulatory Compliance and Safety
Information” section in this document.
Figure 27 Connecting the IF Cable (to the Wireless Transverter)
If you will be using the diversity feature, attach a second cable to the Diversity-ODU/Output connector.
This completes the procedure for installing and cabling a power feed panel. To install the wireless
transverter, refer to the transverter vendor’s instructions.
OUTPUT
-48V ,7A
OUTPUT
-48V ,7A
28541
PWR
ON
PWR
ON
DIVERSITY
ODU
ODU
MC
MC
MAIN
MAIN
CONTROL
DIVERSITY
ODU
ODU
MC
MC
PWR
ON
PWR
ON
DIVERSITY
ODU
ODU
MC
MC
MAIN
OUTPUT
-48V ,7A
OUTPUT
-48V ,7A
OUTPUT
-48V ,7A
OUTPUT
-48V ,7A
28542
PWR
ON
PWR
ON
DIVERSITY
ODU
ODU
MC
MC
MAIN
PWR
ON
PWR
ON
DIVERSITY
ODU
ODU
MC
MC
MAIN
OUTPUT
-48V ,7A
OUTPUT
-48V ,7A