Installation guide
Table Of Contents
- CiscouBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation an...
- If You Need More Information
- Wireless Modem Card and Subsystem Overview
- Field-Replaceable Units
- Installation Prerequisites
- Removing and Installing the Wireless Modem Card
- Installing the Power Feed Panel
- Configuring a Wireless Modem Card
- Command Reference
- Syntax Conventions
- Startup Commands
- Installation and Configuration Commands
- Operating Commands
- Monitoring the System
- Troubleshooting
- show controllers radio
- radio histogram
- radio byteErrorHist
- show interfaces radio (histspec)
- show interfaces radio (histdata)
- debug radio
- Images and Image Repositories
- radio image-add
- radio image-move
- show interfaces radio (imagehdr)
- show radio repository
- radio snapshot
- radio scope-output
- radio timeline
- show interfaces radio (tlspec)
- show interfaces radio (tldata)
- Regulatory Compliance and Safety Information
- FCC Registration and Requirements
- Translated Safety Warnings
- Short-Circuit Protection Warning
- Disconnect Device Warning
- Lightning Activity Warning
- Installation Warning
- Jewelry Removal Warning
- Supply Circuit Warning
- Service Personnel Warning
- Product Disposal Warning
- Faceplates and Cover Panel Requirement
- Chassis—Rack-Mounting and Servicing Warning
- Restricted Area Warning
- Earthed Conductor Warning
- Power Cabling Warning
- Ground Connection Warning
- Power Supply Wiring Warning
- Copper Conductors Warning
- Exposed DC Power Wire Warning
- 48 VDC Power System Warning
- SELV-IEC 60950 DC Power Supply Warning
- DC Power Disconnection Warning
- DC Input Wiring Warning
- Ground Wire Connection Warning
- Ground Conductor Warning
- No. 26 AWG Wire Warning
- Coaxial Cable Specification Warning
- Transverter Location Warning
- Obtaining Documentation
- Obtaining Technical Assistance
26
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Installing the Power Feed Panel
Figure 21 Stripping the Wire
Step 4 Insert the stripped ends of the wire in the removable wiring block according to the scheme in Figure 22.
Figure 22 illustrates the polarity of each connection. The terminal on the left is for the –48 VDC wire.
The terminal on the right is for the positive return wire.
Figure 22 Wiring Connections
Step 5 Secure the wires using the 1/8-inch flat-blade screwdriver to tighten the screws in the top of the
terminal block.
Step 6 Connect the DC input wiring to the DC source.
Warning
For personal safety, the ground wire must connect to safety (earth) ground at both the equipment
and supply side of the DC wiring (unless the local electrical code requirements are different). To
see translations of the warnings that appear in this publication, refer to the “Regulatory
Compliance and Safety Information” section in this document.
Step 7 Plug the terminal block into the receptacle on the power feed panel. (See Figure 23.)
0.25 in.
(6.35 mm)
27285
24919
Securing
screws
-48 VDC
-
+