Installation guide

2
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
If You Need More Information
• Obtaining Documentation, page 124
• Obtaining Technical Assistance, page 125
If You Need More Information
The Cisco IOS software running on your router contains extensive features and functionality. The
effective use of many of these features is easier if you have more information. For additional information
on configuring and maintaining the Cisco uBR7200 series router, the following documentation resources
are available:
• For hardware installation and maintenance information on the Cisco uBR7200 series router, refer to
the Cisco uBR7200 Series Universal Broadband Router Hardware Installation Guide that shipped
with your Cisco uBR7200 series router.
• For software configuration information on the Cisco uBR7200 series router, refer to the
Cisco uBR7200 Series Universal Broadband Router Software Configuration Guide that shipped
with your Cisco uBR7200 series router.
• For Cisco IOS software configuration information, refer to the modular configuration and modular
command reference publications in the Cisco IOS software configuration documentation set that
corresponds to the software release installed on your Cisco hardware.
Note You can access Cisco IOS software configuration documentation on the World Wide Web
at http://www.cisco.com, http://www-china.cisco.com, or http://www-europe.cisco.com.
• For international agency compliance, safety, and statutory information for wide-area network
(WAN) interfaces for the Cisco uBR7200 series, refer to the appendix containing the “Regulatory
Compliance and Safety Information” in the Cisco uBR7200 Series Universal Broadband Router
Hardware Installation Guide.
• To obtain general information about documentation, refer to the “Obtaining Documentation” section
on page 124, or call customer service at 800 553-6387 or 408 526-7208. Customer service hours are
5:00 a.m. to 6:00 p.m. Pacific time, Monday through Friday (excluding Cisco-observed holidays).
You can also send e-mail to [e-mail], or you can refer to the Cisco Information Packet that
shipped with your router.
Wireless Modem Card and Subsystem Overview
The Cisco high-speed point-to-point broadband fixed wireless system provides a fixed, dedicated
wireless link from one site to another. This link delivers full-duplex data in the Unlicensed National
Information Infrastructure (U-NII) band (5.725 to 5.825 GHz).
The broadband fixed wireless system consists of a Cisco uBR7200 series universal broadband router
(Cisco uBR7223, Cisco uBR7246, or Cisco uBR7246 VXR) and one or more wireless modem cards (see
Figure 1), each with a power feed panel (see Figure 2) at each site. (The diversity option, which
minimizes the effects of fading, uses two wireless transverters at each site, one for each of two antennas.)
Note Wireless transverters must be purchased from a third-party vendor. Refer to that vendor’s
documentation for installation instructions.