Installation guide

10
Cisco uBR7200 Series Universal Broadband Router Wireless Modem Card and Subsystem Installation and Configuration
78-6030-03
Installation Prerequisites
Wireless Modem Card
You need the following tools and parts to remove and replace a wireless modem card. If you need
additional equipment, contact a service representative for ordering information.
• New wireless modem card
• Number 2 Phillips screwdriver
• SMA production torque wrench
• Your own electrostatic discharge (ESD)-prevention equipment or the disposable grounding wrist
strap included with all upgrade kits, FRUs, and spares
• Antistatic mat or surface
• Static shielding bag
• Shielded CAT-5 cable with RJ-45 connectors and plenum-rated coaxial cable with SMA connectors
for connections between the modem card and the power feed panel. (Standard sets of these cables
can be purchased from Cisco.)
Note If you are replacing a wireless modem card, these cables are already installed.
Power Feed Panel
You need the following tools and parts to install the power feed panel in an equipment rack or on a wall.
If you need additional equipment, contact a service representative for ordering information.
• Power feed panel
• Number 2 Phillips screwdriver
• Bracket kit (provided)
• Rack- or wall-mount screws
• 1/8-inch flat-blade screwdriver
• 5/16-inch open-end wrench
• SMA production torque wrench
• 50-ohm coaxial cables with N-type (male) connectors for IF control
• Shielded CAT-5 outdoor-rated control cables with DB-9 (male) and LEMO-type (8 pin, P, 1K series)
connectors
Note If a lightning protection device is installed between the DB-9 and LEMO-type
connectors, there may be one logical cable, but two physical cables. The portion of the
cable that is located indoors does not need to be outdoor rated.
• –48 VDC power supply
• Ground lug (in grounding kit provided)