User guide

Disabling a Rule Set by Using Voice Commands
Procedure
Step 1
Call and sign in to Connection.
Step 2
When Connection asks, "What do you want to do," say:
"Setup Options." (Connection temporarily switches to the phone keypad.)
Step 3
On the phone keypad, select the option Transfer Settings, then Personal Call Transfer Rules, and Disable
a Transfer Rule Set.
Connection plays the prompt to disable a rule set only when there is a rule set that is enabled but not
active.
Note
Step 4
Follow the prompts to disable the rule set.
To switch back to using voice commands, keep pressing * until you hear the "Voice Command
Conversation" prompt.
Tip
Using the Transfer All Rule Set
The Transfer All rule set contains a single rule that forwards all of your calls to a specific destination for a
specified time. Transfer All is the only rule set that you must set by phone. Cisco Unity Connection activates
the rule set and displays it on the Call Transfer Rule Sets page of the Personal Call Transfer Rules web tool.
When you enable Transfer All, it immediately becomes your active rule set for the duration specified. If a
transferred call is not answered at the Transfer All destination, Connection transfers the call to voicemail.
Enabling the Transfer All Rule Set by Using the Phone Keypad
Procedure
Step 1
Call and sign in to Connection.
Step 2
At the Main menu, select the option Setup Options, then Transfer Settings, and Personal Call Transfer
Rules.
Step 3
Follow the prompts to transfer all calls to voicemail or to a specific phone number, and to set the number of
days you want the Transfer All rule set to be active.
A day ends at 11:59 p.m., so a duration of one day means until the end of the current day (11:59 p.m.),
two days is through the end of tomorrow, and so on. You can enter from 1-999 days for duration.
Tip
User Guide for the Cisco Unity Connection Phone Interface (Release 8.x)
OL-21232-01 73
Disabling a Rule Set by Using Voice Commands
Using the Transfer All Rule Set