Specifications

5-16
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 5 Configuring System Components
Configuring SIP Call Control Parameters
If you plan to use Outcall or Unsolicited Notify for MWI, the MWI relay must be enabled on the central
(local) Cisco Unified CME and the other Cisco Unified CME routers must subscribe to this one. The
central one will keep track of which numbers are defined where and pass on the MWI messages
accordingly.
If you plan to use Subscribe-Notify for MWI, then the individual gateways must use Cisco Unity Express
as their MWI server.
Note Cisco Unity Express does not support automatic MWI synchronization if the WAN link between
Cisco
Unity Express and Cisco Unified CME is disrupted. You must manually synchronize the MWI if
it is out of synch.
The detailed MWI relay design guide, the MWI Relay section of the Cisco Unified
Communications Manager Express Solution Reference Network Design Guide, is located at
http://www.cisco.com/en/US/docs/voice_ip_comm/cucme/srnd/design/guide/cmesrnd.html.
The commands listed in the following are not available when Cisco Unity Express is working in
Cisco Unified Communications Manager mode.
The following instructions describe how t o provision Cisco Unified CME sites:
– Defining a Cisco Unified CME Site (Site Provisioning), page 16
– Deleting a Cisco Unified CME Site, page 18
Note The following procedures replace the following EXEC mode command found in
Cisco
Unity Express 3.1 and earlier versions, whose purpose was to provision the single
Cisco
Unified CME it supported:
web admin cme hostname [hostname] username [username] password [password].
Although this command has not been deprecated, when you have multiple Cisco Unified CME systems,
this command will apply only to the central (local) site.
Defining a Cisco Unified CME Site (Site Provisioning)
Prerequisites
Cisco Unity Express 3.2 or a later version
SUMMARY STEPS
1. config t
2. site name [site-name | local ]
3. site-hostname hostname
4. description “text”
5. web username username password password
6. web credentials hidden username-password-hash
7. xml username username password password
8. xml credentials hidden username-password-hash
9. exit