Specifications

5-12
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 5 Configuring System Components
Configuring SIP Call Control Parameters
Examples
The following example displays the output of the show ccn subsystem sip command.
se-10-0-0-0# show ccn subsystem sip
SIP Gateway: 172.19.167.208
SIP Port Number: 5060
DTMF Relay: sip-notify, sub-notify
MWI Notification: sub-notify
Transfer Mode: consult (REFER)
Configuring the MWI On and Off Extensions (Not Available in Cisco SRST
Mode)
Cisco Unity Express uses the MWI on and off extensions with the affected telephone extension to
generate a SIP call to Cisco Unified CME, which changes the status of the telephone’s MWI light.
This configuration is required only if the MWI notification option is configured as outcall. (See the
earlier section “Configuring the MWI Notification Option” on page 8.)
Prerequisites
Verify that the MWI on and off extensions are configured on Cisco Unified CME; otherwise, the MWI
light will not work.
Required Data for This Procedure
The following information is required to configure the MWI on and off extensions:
• Extension number dedicated to the MWI on extension
• Extension number dedicated to the MWI off extension
SUMMARY STEPS
1. config t
2. ccn application ciscomwiapplication
3. parameter strMWI_ON_DN on-extension
4. parameter strMWI_OFF_DN off-extension
Step 4
end
Example:
se-10-0-0-0(config-sip)# end
Returns to privileged EXEC mode.
Step 5
show ccn subsystem sip
Example:
se-10-0-0-0# show ccn subsystem sip
Displays SIP configuration parameters.
Command or Action Purpose