Specifications

5-11
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 5 Configuring System Components
Configuring SIP Call Control Parameters
ephone-dn 35
mwi sip
For Cisco SRST Mode
sip-ua
.
.
mwi-server ipv4:10.100.9.6 transport udp port 5060 unsolicited
number 2010
.
call-manager-fallback.
mwi relay
Note The SIP server IP address used in these commands must be the IP address of Cisco Unity Express. In the
examples shown above, this is 10.100.9.6.
SUMMARY STEPS
1. config t
2. ccn subsystem sip
3. mwi sip {outcall | sub-notify | unsolicited}
4. end
5. show ccn subsystem sip
DETAILED STEPS
Command or Action Purpose
Step 1
config t
Example:
se-10-0-0-0# config t
Enters configuration mode.
Step 2
ccn subsystem sip
Example:
se-10-0-0-0(config)# ccn subsystem sip
Enters SIP configuration mode.
Step 3
mwi sip {outcall | sub-notify | unsolicited}
Example:
se-10-0-0-0(config-sip)# mwi sip sub-notify
Specifies the MWI notification methods for SIP calls.
The default is outcall.
• outcall —Sends MWI notifications using
SIP
outcall.
• sub-notify—Sends MWI notifications using
SIP
Notify.
• unsolicited—Sends MWI notifications using
SIP
Unsolicited Notify.