Specifications

5-7
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 5 Configuring System Components
Configuring SIP Call Control Parameters
SUMMARY STEPS
1. config t
2. ccn subsystem sip
3. dtmf-relay {rtp-nte | sub-notify | info | sip-notify}
To configure more than one signal option, specify them using a single dtmf-relay command.
4. end
5. show ccn subsystem sip
DETAILED STEPS
sip-notify, rtp-nte,
sub-notify, info
rtp-nte rtp-nte rtp-nte
sip-notify, rtp-nte,
sub-notify, info
no support
2
sub-notify info
1. For incoming call. For outgoing call, the remote end decides between rtp-nte and sip-notify.
2. No support for rtp-nte and sip-notify.
Table 5-1 DTMF Relay Option Combinations (continued)
Cisco Unity Express
Configuration
Option Supported at
Remote End
Option for Incoming
DTMF to
Cisco Unity Express
Option for Outgoing
DTMF from
Cisco Unity Express
Command or Action Purpose
Step 1
config t
Example:
se-10-0-0-0# config t
Enters configuration mode.
Step 2
ccn subsystem sip
Example:
se-10-0-0-0(config)# ccn subsystem sip
Enters SIP configuration mode.