Specifications

22-15
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 22 Registering Cisco Unity Express Endpoints to Cisco Unified Messaging Gateway
Refreshing Locations
To list all configured remote location entries on Cisco Unity Express 3.1, use the EXEC-mode show
network locations configured command. This command replaces the old show network locations
command.
Refreshing Locations
To manually refresh a cached location entry on Cisco Unity Express 3.1, use the network location cache
refresh id command in EXEC-mode. This command will not generate any response if it is performed
successfully. Otherwise, an error message appears.
Setting the Expiration for Cached Locations
To set the expiration time for a cached location on Cisco Unity Express 3.1, use the network location
cache expiry int command in config-mode. The int value stands for number of days. By default, this
value is set to 4. The no command will set the value back to its default value. The value is persisted by
means of the nvgen method. It is not stored in the database.
Overloading a NAT Device: the Consequences for Endpoints
One endpoint can be configured to get to its primary messaging gateway with complete connectivity if :
• Two Cisco Unity Express endpoints are behind a NAT device that has only one IP address to assign
--an overload situation--
• Those endpoints have two different messaging gateways configured as primary messaging gateways,
Note The other endpoint can only do HTTP-related activities (assuming proper configuration) and not the
SMTP activities.