Specifications

13-23
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 13 Networking Cisco Unity Express
Configuring the Broadcast Message VPIM ID for a Network Location
Configuring the Broadcast Message VPIM ID for a Network
Location
Use the following procedure to configure the VPIM ID for broadcast messages for a network location.
Required Data for This Procedure
• Network location ID
• Network location VPIM ID
SUMMARY STEPS
1. config t
2. network location id location-id
3. voicemail broadcast vpim-id vpim-id
4. end
5. exit
DETAILED STEPS
Command or Action Purpose
Step 1
config t
Example:
se-10-0-0-0# config t
se-10-0-0-0(config)#
Enters configuration mode.
Step 2
network location id location-id
Example:
se-10-0-0-0(config)# network location id 15
Specifies the network location.
Step 3
voicemail broadcast vpim-id vpim-id
Example:
se-10-0-0-0(config-location)# voicemail broadcast
vpim-id 159a
Enters location configuration mode and specifies the
VPIM ID for the location. Valid VPIM IDs contain
letters, numbers, underscore (_), dash (-), and dot (.).
The maximum length is 32 characters.