Specifications

13-14
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 13 Networking Cisco Unity Express
Adding Remote Subscribers to the Local Directory
EXEC Mode
Use this Cisco Unity Express EXEC mode procedure to configure remote subscribers on the local
system.
Required Data for This Procedure
The following information is required to configure remote subscribers on the local system:
• Remote username
• Remote location ID
• Remote subscriber’s first name, last name, and full name for display purposes
SUMMARY STEPS
1. remote username username location location-id create
2. remote username username fullname display display-name
3. remote username username fullname first first-name
4. remote username username fullname last last-name
Step 3
remote username username phonenumber extension-number
Example:
se-10-0-0-0(config)# remote username user1
phonenumber 75555
Associates the remote subscriber username with
extension-number.
The local system does not verify the remote extension
number.
An error message appears if one of the following
conditions occurs:
• username does not exist.
• The length of extension-number does not fall
within the maximum and minimum extension
lengths for the subscriber’s location.
Step 4
exit
Example:
se-10-0-0-0(config)# exit
se-10-0-0-0#
Exits configuration mode.
Command or Action Purpose