Specifications

13-13
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 13 Networking Cisco Unity Express
Adding Remote Subscribers to the Local Directory
Configuration Mode
Use this Cisco Unity Express configuration mode procedure to configure remote subscribers on the local
system.
Required Data for This Procedure
The following information is required to configure remote subscribers on the local system:
• Remote username
• Remote subscriber’s extension number
• Remote location ID
SUMMARY STEPS
1. config t
2. remote username username location location-id create
3. remote username username phonenumber extension-number
4. exit
DETAILED STEPS
Command or Action Purpose
Step 1
config t
Example:
se-10-0-0-0# config t
se-10-0-0-0(config)#
Enters configuration mode.
Step 2
remote username username location location-id create
Example:
se-10-0-0-0(config)# remote username user1 location
sjc create
Adds the subscriber with username at the location
location-id to the local directory.
An error message appears if one of the following
conditions occurs:
• A local subscriber, group, or remote subscriber
exists with this username.
• The maximum number of remote subscribers is
already configured on the system.
• location-id does not exist.
• location-id is the local location.