Specifications

12-11
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 12 Configuring Message Notification
Configuring System-Wide Settings
Step 5
voicemail notification connect-timeout seconds
Example:
se-10-0-0-0(config)# voicemail notification
connect-timeout 60
(Optional) Specifies the number of seconds
after which an outgoing message notification
call is disconnected and considered a failed
call. Valid values are 12 to 96. The default
is 48.
This value applies only to phone devices and
numeric pagers.
Step 6
voicemail notification allow-login
Example:
se-10-0-0-0(config)# voicemail notification allow-login
(Optional) Enables a subscriber to log in to
voice mail during an outgoing notification
call. The default is disabled.
If enabled, the system provides the subscriber
with an option to log into voice mail to
retrieve the message.
Step 7
voicemail notification text prefix {append “text message”
| delimiting character}
Example:
se-10-0-0-0(config)# voicemail notification text prefix
append “You have a new voicemail.”
(Optional, Cisco Unity Express 8.0 and later
versions only) Appends a text message
preceding a voicemail notification on a
system-wide basis.
Step 8
voicemail notification text suffix {append “text message”
| delimiting character}
Example:
se-10-0-0-0(config)# voicemail notification text suffix
append “VoiceMail Administration.”
(Optional, Cisco Unity Express 8.0 and later
versions only) Appends signature text
following the notification text on a
system-wide basis.
Step 9
voicemail configuration outgoing-email from-address
email-address
Example:
se-10-0-0-0(config)# voicemail configuration
outgoing-email from-address [e-mail]
Configures an address to use in the From field
of outgoing Cisco Unity Express e-mail
messages.
• email-address—Name and domain name.
Maximum length is 128 characters
Step 10
end
Exits configuration mode.
Step 11
show voicemail notification
Example:
se-10-0-0-0# show voicemail notification
Displays the configured message notification
settings.
Step 12
show voicemail notification restriction-table
Example:
se-10-0-0-0# show voicemail notification restriction-table
Displays the configured restriction table.
Command or Action Purpose