Specifications

12-9
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 12 Configuring Message Notification
Configuring System-Wide Settings
Notifications to Text Pagers
The system sends an e-mail message to the configured e-mail address and creates one text page for each
new message received.
Note If no STMP server is configured, the system does not send text pager notifications.
The subject of the e-mail message is “Message Notification.” The body of the e-mail message contains
the message type, extension or user ID, message sender, and the message text configured by the message
recipient during notification setup. This text will be the same for all messages received by this
subscriber.
Following is a sample e-mail message:
Message Type: Urgent
Message for: userA
Message from: userB
New voicemail for number 1122
If the system cannot deliver the e-mail, the system does not generate a message delivery failure
notification.
Configuring System-Wide Settings
Follow this procedure to set the system-wide message notification settings.
Prerequisites
Before configuring the message notification feature, you must first configure:
• SMTP server hostname
• SMTP authentication values (user ID and password or credential string)
• Restriction table
Cisco Unity Express 8.0 or a later version is required to append a text message preceding a notification
or to append a signature message following a notification.
To configure the SMTP parameters, see “Configuring SMTP Parameters” on page 60.To configure the
restriction table parameters, see “Configuring Restriction Tables” on page 32.
Required Data for This Procedure
• User IDs or group names if a subset of subscribers or groups will have access to message notification
• Notification preference
• Number of seconds for the connection timeout
• If you want to add phone numbers to the restriction table:
– Minimum and maximum number of digits in a dial-string
– At least one dial-string pattern