Specifications

11-5
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 11 Configuring VoiceView Express
Configuring the Phone-Authentication Service
The following is sample output for the show voiceview sessions command:
se-10-0-0-0# show voiceview sessions
Mailbox RTP User ID Phone MAC Address
1013 Yes user1 0015.C68E.6C1E
1016 No user5 0015.629F.8706
1015 No user3 0015.63EE.3790
1014 Yes user6 0015.629F.888B
1009 No user9 0015.6269.57D2
1012 No user10 0016.4676.4FCA
1001 No user8 0009.B7F7.5703
1004 Yes user11 000C.30DE.5EA8
8 session(s)
3 active RTP stream(s)
Configuring the Phone-Authentication Service
Prior to release 7.0, Cisco Unity Express provided an authentication service that handled only
VoiceView Express authentication requests from the IP phones during the playback and recording of
voice messages and greetings. There was no authentication service for any other IP phone applications
that required audio streaming.
Beginning in release 7.0, the phone authentication service was provided as part of IOS. As part of IOS,
the authentication service to be used with any phone service application on the network. For release 7.0
and later, Cisco Unified CME acts as the primary authentication server.
Prerequisites For Release 7.0 and Later
On Cisco Unified CME, you must perform the following steps before configuring the phone
authentication service on Cisco Unity Express:
• Configure the URL for the authentication service using the following command:
url authentication http://cme-ip-address/CCMCIP/authenticate.asp
• Configure the authentication username and password using the following command:
authentication credential username password
This username and password must match the username and password configured in the following
procedure.
• (Cisco Unified CME 8.0 and later) Enable Web Access using the following command in
telephony-service configuration mode:
service phone webAccess 0
Prerequisites for Release 3.2 and Earlier
On Cisco Unified CME, you must perform the following step before configuring the phone
authentication service on Cisco Unity Express:
• Configure the URL for the authentication service using the following command:
url authentication http://cue-ip-address/voiceview/authentication/authenticate.do