Specifications

7-36
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 7 Configuring Voice Mail
Configuring System-Wide Voice-Mail Parameters
DETAILED STEPS
Enabling Secure Messaging Support for a Remote Network Location
This procedure enables secure messaging for all incoming messages to a remote network location. If this
setting is not enabled, then an NDR message will be generated for any messages marked secure sent to
the remote location.
Prerequisite
The remote network location must be configured. See the “Configuring Network Locations” section on
page 3.
SUMMARY STEPS
1. config t
2. network location id number
3. voicemail secure-messaging
Command or Action Purpose
Step 1
config t
Example:
se-10-0-0-0# config t
Enters configuration mode.
Step 2
voice mailbox owner name [type announcement-only]
[size
seconds]
Example:
se-10-0-0-0(config)# voice mailbox owner user8
se-10-0-0-0(config-mailbox)#
Enters voice-mailbox configuration mode.
Step 3
secure-messaging incoming
Example:
se-10-0-0-0(config-mailbox)# secure-messaging
incoming
Configures secure messaging for all incoming
messages to the voice mailbox.
Step 4
secure-message outgoing {always | ask | never |
private}
Example:
se-10-0-0-0(config-mailbox)# secure-messaging
outgoing always
Configures the secure messaging setting for all
outgoing messages from the voice mailbox.