Specifications

7-7
Cisco Unity Express Voice-Mail and Auto-Attendant CLI Administrator Guide for 3.0 and Later Versions
OL-14010-09
Chapter 7 Configuring Voice Mail
Planning Mailbox Configuration
Step 6
greeting {alternate | standard}
Example:
se-10-0-0-0(config-mailbox)# greeting standard
Specifies which greeting to use when a caller reaches
the mailbox. The mailbox owner can record standard
and alternate greetings from the telephone user
interface (TUI). If the subscriber has not recorded any
messages, the default recording is used.
Note Beginning in Cisco Unity Express 7.1,
additional options for the greeting command
are available. See
Configuring Multiple
Greetings, page 10.
Step 7
mailboxsize seconds
Example:
se-10-0-0-0(config-mailbox)# mailboxsize 300
Specifies the storage size of the mailbox, in seconds.
This is the same as the size parameter mentioned in
Step 2.
Step 8
messagesize seconds
Example:
se-10-0-0-0(config-mailbox)# messagesize 120
Specifies the maximum size of an incoming message,
in seconds.
Step 9
tutorial
Example:
se-10-0-0-0(config-mailbox)# tutorial
Enables the mailbox tutorial program when the
telephone subscriber logs in to the voice-mail system
for the first time. The default is enabled. If the
tutorial command is enabled after the mailbox is
configured, the tutorial will start again but will
confirm the subscriber’s previous choices, rather than
erasing them all. Use the no tutorial command to
disable the tutorial.
Step 10
zerooutnumber “number”
Example:
se-10-0-0-0(config-mailbox)# zerooutnumber “2100”
Specifies the extension where a caller is routed when
the caller presses “0’ to reach an operator after being
transferred to a subscriber’s mailbox.
Step 11
end
Example:
se-10-0-0-0(config-mailbox)# end
Exits mailbox configuration mode.
Step 12
exit
Example:
se-10-0-0-0(config)# exit
Exits configuration mode.
Command or Action Purpose