Datasheet

C-9
Cisco UCS C24 Server Installation and Service Guide
OL-26647-01
Appendix C RAID Controller Considerations
Embedded MegaRAID Controller
Launching the LSI Embedded RAID Configuration Utility
Launch the utility by pressing Ctrl+M when you see the prompt during system boot.
For more information about using the Embedded MegaRAID software to configure your disk arrays, see
the LSI Embedded MegaRAID Software User Guide.
Installing LSI MegaSR Drivers For Windows and Linux
Note The required drivers for this controller are already installed and ready to use with the LSI SWRAID
Configuration Utility. However, if you will use this controller with Windows or Linux, you must
download and install additional drivers for those operating systems.
This section explains how to install the LSI MegaSR drivers for the following supported operating
systems:
• Microsoft Windows Server
• Red Hat Enterprise Linux (RHEL)
• SuSE Linux Enterprise Server (SLES)
For the specific supported OS versions, see the Hardware and Software Interoperability Matrix for your
server release.
This section contains the following topics:
• Downloading the LSI MegaSR Drivers, page C-10
• Microsoft Windows Driver Installation, page C-10
• Linux Driver Installation, page C-12