Datasheet

Cisco UCS Cisco UCS C220 M3 High-Density Rack Server (Large Form Factor Hard Disk Drive Model)

CONFIGURING the SERVER

Approved Configurations

(1) 1-CPU Configurations

Mezzanine cards are not supported for 1-CPU configurations, Therefore, only the following RAID

controllers are supported for single-CPU configurations:

■ Embedded RAID (on motherboard)

■ LSI MegaRAID SAS 9266-8i (PCIe slot 1 only)

■ LSI MegaRAID SAS 9266CV-8i (PCIe slot 1 only)

■ LSI MegaRAID SAS 9285CV-8e (PCIe slot 1 only)

RAID Configuration Options (not available for embedded RAID)

R2XX-SRAID0 Enable Single Disk Raid 0 Setting (for the following PIDs only):

■ UCS-RAID-9266-NB

■ UCS-RAID-9266CV

■ UCSC-RAID-11-C220

■ UCSC-RAID-MZ-220

R2XX-RAID0 Factory preconfigured RAID striping option

Enable RAID 0 Setting. Requires a minimum of one hard drive.

R2XX-RAID1 Factory preconfigured RAID mirroring option

Enable RAID 1 Setting. Requires exactly two drives with the same size, speed,

capacity.

R2XX-RAID5 Factory preconfigured RAID option

Enable RAID 5 Setting. Requires a minimum of three drives of the same size,

speed, capacity.

R2XX-RAID6 Factory preconfigured RAID option

Enable RAID 6 Setting. Requires a minimum of four drives of the same size,

speed, capacity.

R2XX-RAID10 Factory preconfigured RAID option

Enable RAID 10 Setting. Requires a even number of drives (minimum of four

drives) of the same size, speed, capacity.

NOTE: Although RAID levels 50 and 60 are not orderable from the factory, they are

supported for selected controllers as shown in

Table 5

NOTE: PCIe slot 2 is not supported for 1-CPU configurations

Table 7 Available Plug-In PCIe Card RAID Options (continued)

Product ID (PID) PID Description