Installation guide

Hardware Installation Guide for Cisco UCS E-Series Servers

Hardware Requirements

Cisco UCS E-Series Server Modules Hardware Installation Guide

Figure 4 Front Panel of the Double-Wide E-Series Server

1 Power Switch 2 Reset Switch.

Note This reset all CMOS settings.

3 LEDs 4 VGA Port

5 Serial Port 6 Dual SD card slots and cover

Note Do not remove the SD card in the SD0

card slot when the system is in

operation. The SD card in the SD0

card slot contains the Integrated

Management Controller software and

should always be present.

7 Gigabit Ethernet Ports (GE2 and GE3) 8 Management Port

9 USB Ports.

Note Each port can provide up to 500 mA of

current. Devices with higher power

requirements, such as CD/DVD ROM

will need its own external power.

10 (Optional) HDD2, PCIe assembly or Blank

slot.

11 Hard Disk Drives (HDD0 and HDD1) 12 (Optional) Alternate PCIe Assembly with

FCoE port

Note For use with Cisco PCIe assembly

modules only.

13 (Optional) Alternate PCIe Assembly with

4-Gigabit Ethernet ports

Note For use with Cisco PCIe assembly

modules only.