Installation guide

Hardware Installation Guide for Cisco UCS E-Series Servers
Installing E-Series Servers in Cisco ISR G2 Routers
30
Cisco UCS E-Series Server Modules Hardware Installation Guide
OL-26447-01
Step 4 Slide the plastic bracket over the end of the PCIe card.
Step 5 Slide the PCIe assembly into the server module.
Step 6 Connect the flex assembly onto the motherboard. Be careful not to place any stress on the connector
contacts.
Step 7 Replace the screw that secures the flex assembly in place and tighten.
Step 8 Replace the two screws that secure the plastic bracket to the motherboard and tighten
Step 9 Tighten the captive screws on the faceplate.
Installing and Replacing DIMMS
The single-wide E-Series Servers support up to 16 GB DDR3 DIMMs and the double-wide E-Series
Servers support up to 48 GB DDR3 DIMMs.
Caution Always wear an ESD-preventive wrist strap and ensure that it makes good contact with your skin when
you remove or install DIMMs. Connect the equipment end of the wrist strap to the metal part of the
chassis.
Caution Handle DIMMs by the edges only. DIMMs are ESD-sensitive components and can be damaged by
mishandling.
Warning Only trained and qualified personnel should be allowed to install or replace this equipment. Statement
1030
Warning Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Warning No user-serviceable parts inside. Do not open. Statement 1073
Warning This unit might have more than one power supply connection. All connections must be removed to
de-energize the unit. Statement 1028
Warning Blank faceplates and cover panels serve three important functions: they prevent exposure to
hazardous voltages and currents inside the chassis; they contain electromagnetic interference (EMI)
that might disrupt other equipment; and they direct the flow of cooling air through the chassis. Do not
operate the system unless all cards, faceplates, front covers, and rear covers are in place.
Statement
1029