Installation guide

Hardware Installation Guide for Cisco UCS E-Series Servers
Hardware Requirements
3
Cisco UCS E-Series Server Modules Hardware Installation Guide
Supported PCIe Cards and SFP Transceivers
The Double-wide E-Series Server supports the PCIe cards listed in Table 2.
Table 3 lists the supported SFP transceivers that are supported on the E100-PCIE10GEFCOE.
E-Series Servers
E-Series Servers are available in the following two factor form:
• Single-wide interface (See Figure 1 and Figure 3)
• Double-wide interface (See Figure 4 and Figure 5)
Router Platforms 2911, 2921, 2951, 3925, 3925e,
3945, 3945e
2921, 2951
2
, 3925, 3925e, 3945,
3945e
2921, 2951
2
, 3925, 3925e, 3945,
3945e
Maximum
Number of
E-Series Servers
Per ISR G2
2900 ISR G2—1 E-Series Server
2951 ISR G2—2 E-Series Servers
3925 ISR G2—2 E-Series Servers
3945 ISR G2—4 E-Series Servers
2900 ISR G2—1 E-Series Server
3900 ISR G2—1 E-Series Server
2900 ISR G2—1 E-Series Server
3900 ISR G2—1 E-Series Server
1. All hardware drives within the E-Series Server must be installed with the same type of storage device; either all SAS drives or all SATA drives.
2. 2921 and 2951 support 4-core only.
Table 1 E-Series Server Hardware at a Glance (continued)
Table 2 Supported PCIe Cards
PCIe Card SKU Description
E100-PCIE10GEFCOE 1 port SFP+,PCIe,10GE fiber, FCOE support
E100-PCIE-4PGE 4 port GE, PCIe card, RJ-45
Table 3 Supported SFP transceivers on the E100-PCIE10GEFCOE
SFP Description
SFP-H10GB-CU1M SFP+ 10GBASE-CU 1 Meter cable, passive
SFP-H10GB-CU3M SFP+ 10GBASE-CU 3 Meter cable, passive
SFP-H10GB-CU5M SFP+ 10GBASE-CU 5 Meter cable, passive
SFP-H10GB-ACU7M SFP+ 10GBASE-CU 7 Meter cable, active
SFP-H10GB-ACU10M SFP+ 10GBASE-CU 10 Meter cable, active
JDSU
(PLRXPL-SC-S43-22-
N) SFP+
SFP+ (Optical)
Cisco SFP-10G-SR SFP+ 10GBase- SR (Optical)