Installation guide

Hardware Installation Guide for Cisco UCS E-Series Servers
Installing E-Series Servers in Cisco ISR G2 Routers
22
Cisco UCS E-Series Server Modules Hardware Installation Guide
OL-26447-01
Figure 11 Installing a Double-Wide E-Series Server in a Cisco ISR G2 Router
Step 5 Push the module into place until you feel the edge connector seat securely into the connector on the
router backplane. The module faceplate should contact the chassis rear panel.
Step 6 Using a number 1 Phillips or flat-blade screwdriver, tighten the captive mounting screws on the module
faceplate.
Step 7 Proceed with connecting the module to the network and power up the router and server module.
Tip See the “Where to Go Next” section on page 33 for information on locating additional hardware
documentation.
Online Insertion and Removal on a Cisco ISR G2 Router
Online insertion and removal provides uninterrupted network operation, maintains routing information,
and ensures session preservation on the Cisco ISR G2 Router. You can use online insertion and removal
to install or replace hardware on the Cisco 3900 series routers without affecting system operations.
OIR procedures require some interaction with Cisco IOS software. For more information on Cisco IOS
software-related tasks, see documents listed in the “Where to Go Next” section on page 33.
Removing the E-Series Server
To shut down a server module on the Cisco ISR G2 router, perform the following steps:
SUMMARY STEPS
1. enable
2. ucse slot shutdown
3. hw-module sm slot oir-stop
1 Double-wideE-Series Server 2 Router chassis