Installation guide

Hardware Installation Guide for Cisco UCS E-Series Servers

Installing E-Series Servers in Cisco ISR G2 Routers

Cisco UCS E-Series Server Modules Hardware Installation Guide

OL-26447-01

–

Installing Blank Faceplates on Cisco ISR G2 Routers, page 18

–

Removing Blank Faceplates from Cisco ISR G2 Routers, page 18

• Preparing Cisco Router Slots for Server Module Installation, page 18

–

Installing Slot Dividers, page 19

–

Removing Slot Dividers, page 20

–

Installing the E-Series Servers, page 20

• Installing the E-Series Servers, page 20

Note Cisco 2900 series do not support online insertion and removal (OIR) of the E-Series Servers.

To avoid damaging the router, turn off the electrical power on the router and disconnect network cables

before inserting or removing the E-Series Servers into the Cisco 2900 routers.

Tools and Equipment Required During E-Series Servers Installation

You will need the following tools and equipment while working with E-Series Servers:

• Number 1 Phillips screwdriver or a small flat-blade screwdriver

• ESD-preventive wrist strap

• (For routers using DC power) Tape to secure DC circuit breaker handle

Summary of Installation Tasks

When installing the E-Series Servers in a Cisco ISR G2 router, perform the following tasks:

Warning

Only trained and qualified personnel should be allowed to install, replace, or service this equipment.

Statement 1030

Warning

To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network

voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Some

LAN and WAN ports both use RJ-45 connectors. Use caution when connecting cables.

Statement 1021

Warning

Hazardous network voltages are present in WAN ports regardless of whether power to the unit is OFF

or ON. To avoid electric shock, use caution when working near WAN ports. When detaching cables,

detach the end away from the unit first.

Statement 1026

Caution To prevent damage to the E-Series Servers, handle the E-Series module by the chassis or frame.