Installation guide

Hardware Installation Guide for Cisco UCS E-Series Servers
Installing E-Series Servers in Cisco ISR G2 Routers
15
Cisco UCS E-Series Server Modules Hardware Installation Guide
Warning Class 1 laser product. Statement 1008
Warning Invisible laser radiation may be emitted from the end of the unterminated fiber cable or connector. Do
not view directly with optical instruments. Viewing the laser output with certain optical instruments
(for example, eye loupes, magnifiers, and microscopes) within a distance of 100 mm may pose an eye
hazard. Statement 1056
The following warnings apply in Australia:
Warning Do not touch the power supply when the power cord is connected. For systems with a power switch,
line voltages are present within the power supply even when the power switch is OFF and the power
cord is connected. For systems without a power switch, line voltages are present within the power
supply when the power cord is connected. Statement 4
Warning This equipment will be inoperable when mains power fails. Statement 198
Warning To avoid electric shock, do not connect safety extra-low voltage (SELV) circuits to telephone-network
voltage (TNV) circuits. LAN ports contain SELV circuits, and WAN ports contain TNV circuits. Both
LAN and WAN ports may use RJ-45 connectors. Use caution when connecting cables. Statement 1021
Warning Hazardous network voltages are present in WAN ports regardless of whether power to the router is
OFF or ON. To avoid electric shock, use caution when working near WAN ports. When detaching
cables, detach the end away from the router first. Statement 1026
Warning Before opening the chassis, disconnect the telephone-network cables to avoid contact with
telephone-network voltages. Statement 1041
Warning This equipment must be installed and maintained by service personnel as defined by AS/NZS 3260.
Incorrectly connecting this equipment to a general-purpose outlet could be hazardous. The
telecommunications lines must be disconnected 1) before unplugging the main power connector or 2)
while the housing is open, or both. Statement 1043
Installing E-Series Servers in Cisco ISR G2 Routers
This section describes the tasks for installing the E-Series Servers on Cisco ISR G2 routers, and contains
the following subsections:
• Tools and Equipment Required During E-Series Servers Installation, page 16
• Installing and Removing Blank Faceplates, page 17