Installation guide

Hardware Installation Guide for Cisco UCS E-Series Servers
Recommended Practices for Cisco UCS E-Series Servers
13
Cisco UCS E-Series Server Modules Hardware Installation Guide
• Install the server away from heating, ventilation, and air-conditioning (HVAC) system and other
large building air movers.
• Install the rack away from areas that may be affected by external vibrations, such garage areas where
there may be moving vehicles or factories with heavy machinary.
• Do not install in a rack that will be placed in a moving vehicle.
General Maintenance Guidelines for E-Series Servers
The following maintenance guidelines apply to E-Series Servers:
• Keep the router chassis area clear and dust-free during and after installation.
• If you remove the chassis cover for any reason, store it in a safe place.
• Do not perform any action that creates a hazard to people or makes equipment unsafe.
• Keep walk areas clear to prevent falls or damage to equipment.
• Follow installation and maintenance procedures as documented by Cisco Systems, Inc.
Safety Warnings for E-Series Servers
The following safety warning statements apply to all hardware procedures involving E-Series Servers
for Cisco ISR G2 routers. Translations of these warnings are available in the Cisco Network Modules
and Interface Cards Regulatory Compliance and Safety Information document, which ships with
individual E-Series Server orders, and is also available online at
http://www.cisco.com/en/US/docs/routers/access/interfaces/rcsi/IOHrcsi.html
Warning IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
SAVE THESE INSTRUCTIONS
Warning This warning symbol means danger. You are in a situation that could cause bodily injury. Before you
work on any equipment, be aware of the hazards involved with electrical circuitry and be familiar
with standard practices for preventing accidents. Use the statement number provided at the end of
each warning to locate its translation in the translated safety warnings that accompanied this device.
Statement 1071
Warning Only trained and qualified personnel should be allowed to install or replace this equipment. Statement
1030