Specifications

Send document comments to [e-mail]
Index
IN-3
Cisco UCS C210 Server Installation and Service Guide
OL-20887-02
SAS riser 3-14
SAS riser battery 3-16
shutting down 3-6
solid state drives 3-30
mass storage controller, see SAS riser 3-14
memory riser
LEDs
3-23
replacing 3-23
motherboard beeps 2-7
motherboard CMOS battery, replacing 3-18
N
NIC modes 2-11
NIC modes, setting 2-8
NIC redundancy 2-9, 2-11
O
operations panel buttons 1-2
operations panel LEDs 3-3
overview of server features 1-3
P
packing list 2-2
PCIe card, Cisco UCS P81E VIC considerations 3-37
PCIe card in hot-swap slot, replacing 3-36
PCIe card in non-hot-swap slot, replacing 3-35
PCIe slots 3-34
physical specifications A-1
population rules for DIMMs 3-25
port locations 1-2
ports, 10 Gb 2-12
power
connecting power cords
2-7
emergency shutdown 3-7
graceful shutdown 3-6
main power mode 3-6
powering off 3-6
power status LED location 1-2, 3-2, 3-3
power supply redundancy 3-10
shutting down 3-6
specifications A-2
standby power mode 3-6
supported power cords B-2
power cords
jumper power cord (figure)
B-7
supported power cords (figure) B-3
power cords supported B-2
powering off 3-6
power plugs B-3
power supplies, replacing 3-10
preparing for server installation 2-3
Q
Quiet Boot, disabling C-2
R
rack installation 2-4
rack requirements 2-4
RAID controller
determine which is installed
C-1
documentation reference C-2
launching setup utility C-2
RAID controller, see SAS riser 3-14
rear panel
features
1-2
ports 1-2
rear panel LEDs 3-5
recovering corrupt BIOS 2-19
related documentation i-vii
required equipment
installation
2-4