Specifications

Send document comments to [e-mail]
3-17
Cisco UCS C460 Server Installation and Service Guide
OL-22326-01z
Chapter 3 Maintaining the Server
Installing or Replacing Server Components
Step 2 Install a new BBU:
a. Connect the cable from the SAS riser to the replacement BBU.
b. Insert the two retaining clips on the rear of the BBU into the chassis wall slots and slide the BBU
toward the chassis rear until it locks into place.
c. Replace the memory riser that you removed for clearance. See Replacing Memory Risers,
page 3-23.
d. Replace the top cover.
e. Replace the server in the rack, replace cables, and then power on the server by pressing the Power
button.
Figure 3-11 Removing and Replacing the RAID Battery Assembly
1 BBU position on inside chassis wall 2 BBU retaining clips
198936
2
1
2