Specifications

Send document comments to [e-mail]
3-13
Cisco UCS C460 Server Installation and Service Guide
OL-22326-01z
Chapter 3 Maintaining the Server
Installing or Replacing Server Components
Step 2 Install a new eUSB drive.
a. Align the connector on the underside of the eUSB drive with the empty drive connector on the
motherboard and push on both ends of the drive evenly to seat the connector.
b. Replace the single mounting screw that secures the eUSB drive to the motherboard standoff.
c. Replace the I/O riser. See Replacing the I/O Riser, page 3-11.
d. Replace the top cover.
e. Replace the server in the rack, replace cables, and then power on the server by pressing the Power
button.
Figure 3-8 Removing and Replacing the eUSB Drive
1 eUSB connectors on motherboard (two) 2 eUSB drive, showing orientation of hole for
securing screw
198884
1
2
1