Specifications

Send document comments to [e-mail]
3-12
Cisco UCS C460 Server Installation and Service Guide
OL-22326-01
Chapter 3 Maintaining the Server
Installing or Replacing Server Components
Figure 3-7 Removing and Replacing the I/O Riser
Replacing an eUSB Drive
The eUSB drive is a small solid-state flash drive card that connects to the motherboard in either of two
eUSB drive connectors. To install or replace the eUSB drive, follow these steps:
Step 1 Remove the eUSB drive you are replacing. See Figure 3-8:
a. Power off the server as described in the “Shutting Down and Powering Off the Server” section on
page 3-6.
b. Slide the server out the front of the rack far enough so that you can remove the top cover.
Note You might have to detach cables from the rear panel to provide clearance.
Caution If you cannot safely view and access the component, remove the server from the rack.
c. Remove the top cover as described in “Removing and Replacing the Server Top Cover” section on
page 3-7.
d. Remove the I/O riser to provide clearance. See Replacing the I/O Riser, page 3-11.
e. Locate the eUSB drive and remove the single screw that secures it to the motherboard standoff.
f. Lift straight up on both ends the eUSB drive to disengage it from the motherboard connector.
1 Retaining clip 2 I/O riser back panel
3 I/O riser
3
1
2
198883