Specifications

Send document comments to [e-mail]
Contents
iv
Cisco UCS C460 Server Installation and Service Guide
OL-22326-01
Using a Clear BIOS Admin Password Jumper on Header J5C3 2-21
Using a Clear CMOS Jumper on Header J5C2 2-22
Updating the CIMC Firmware 2-23
RAID Configurations on Hard Drives 2-23
CHAPTER 3 Maintaining the Server 3-1
Status LEDs and Buttons 3-1
Front Panel LEDs 3-2
Operations Panel LEDs and Buttons 3-3
Rear Panel LEDs and Buttons 3-5
Preparing for Server Component Installation 3-6
Required Equipment 3-6
Shutting Down and Powering Off the Server 3-6
Removing and Replacing the Server Top Cover 3-7
Replaceable Component Locations 3-8
Installing or Replacing Server Components 3-9
Replacing Power Supplies 3-10
Replacing the I/O Riser 3-11
Replacing an eUSB Drive 3-12
Replacing a SAS Riser 3-14
LSI MegaRAID Card Beep Codes 3-16
Replacing the SAS Riser Battery Backup Unit 3-16
Replacing the Motherboard CMOS Battery 3-18
Replacing CPUs and Heatsinks 3-20
Replacing Memory Risers 3-23
Replacing DIMMs 3-25
Memory Performance Guidelines and Population Rules 3-25
DIMM Installation Procedure 3-27
Replacing Fan Modules 3-29
Replacing Hard Drives or Solid State Drives 3-30
Replacing a DVD Drive 3-32
Replacing a PCIe Card 3-34
Replacing a PCIe Card in a Non Hot-Swappable Slot 3-35
Replacing a PCIe Card in a Hot-Swappable Slot 3-36
Special Considerations for the Cisco UCS P81E Virtual Interface Card (N2XX-ACPCI01) 3-37
APPENDIX A Server Specifications A-1
Physical Specifications A-1
Environmental Specifications A-2