Specifications

Send document comments to [e-mail]
2-5
Cisco UCS C460 Server Installation and Service Guide
OL-22326-01
Chapter 2 Installing the Server
Installing the Server In a Rack
Figure 2-2 Installing the Slide Rail Assemblies in the Rack
d. Attach the second slide-rail assembly to the opposite side of the rack.
e. Ensure that the two slide-rail assemblies are level and at the same height.
f. Pull the inner slide rails on each assembly out toward the front of the rack until they hit the internal
stops and lock in place.
Step 2 Attach mounting brackets to the server. See Figure 2-3:
a. Place the mounting bracket (item 1) against the side of the server, with the end of the bracket marked
Front toward the front of the server.
b. Match the three bracket mounting holes with the three mounting pegs (item 3) on the side of the
server.
c. Slide the bracket toward the rear of the server until the metal tab on the bracket (item 2) locks over
the rear mounting peg.
Figure 2-3 Attaching the Mounting Brackets to the Server
1 Rack posts 2 Rear mounting pegs and locking clip
3 Slide rail assembly 4 Front mounting pegs and locking clip
3
1 1
2 4
198153
1 Mounting bracket 2 Metal tab
3 Mounting pegs 4 Removal release clip
5 Installation release clip
198152
1 2
4 5
3