Specifications

Send document comments to [e-mail]
C-3
Cisco UCS C200 Server Installation and Service Guide
OL-20732-02
Appendix C RAID Controller Considerations
How To Enable the ICH10R Onboard Controller
To enable the ICH10R onboard controller, follow these steps:
Step 1 Boot the server and watch for the F2 prompt during bootup.
Step 2 Press F2 when prompted to enter the BIOS Setup utility.
Step 3 Select the Advanced tab of the BIOS Setup utility.
Step 4 Select Mass Storage Controllers Configuration.
Step 5 Set Onboard SATA Controller to Enabled.
Step 6 Set SATA Mode to SW RAID.
Step 7 Press F10 to save your changes and exit the utility.