Specifications

Send document comments to [e-mail]
3-31
Cisco UCS C200 Server Installation and Service Guide
OL-20732-02
Chapter 3 Maintaining the Server
Installing or Replacing Components
Note Be careful to align the arrow-mark on the cable connector with the arrow-mark on the socket to
avoid damaging the connector pins.
Figure 3-18 Removing and Replacing an LSI BBU
If this is a first-time installation of the BBU rather than a replacement, continue with these steps:
Step 3 Install the cable adapter to the LSI card:
a. Remove the LSI MegaRAID card from the PCIe riser. See the “Replacing a PCIe Card (Network
Adapters)” section on page 3-25 for instructions.
b. Install the plastic standoff to the corner of the LSI card near socket J10. The standoff sits on top of
the card and the securing screw enters the standoff from the underside of the card.
c. Align the adapter card over the LSI controller card. The notch in the side of the adapter should align
with the standoff post.
d. Press down firmly to engage the J2 connector on the underside of the adapter with the J10 socket on
the LSI controller card.
e. Swivel the standoff so that the threaded hole at the end of the swing-arm aligns with the screw-hole
in the corner of the adapter.
f. Install the securing screw through the adapter and into the plastic standoff.
g. Connect the cable from the BBU to the socket on the adapter.
Note Be careful to align the arrow-mark on the cable connector with the arrow-mark on the socket to
avoid damaging the connector pins.
1 BBU bracket on fan tray 2 Securing screws (three)
3 BBU (connector J2 is on the underside)
1
2 3