Specifications

Send document comments to [e-mail]
3-18
Cisco UCS C200 Server Installation and Service Guide
OL-20732-02
Chapter 3 Maintaining the Server
Installing or Replacing Components
Step 2 Install a DIMM:
a. With the ejector levers at both ends of the DIMM slot fully open, orient the DIMM’s alignment notch
with the alignment key in the DIMM slot.
b. Press down on both top corners of the DIMM simultaneously until the ejector levers click and lock
in place on the DIMM.
c. Replace the air baffle and the top cover.
d. Replace the server in the rack, replace power cords and any other cables, and then power on the
server by pressing the Power button.
Figure 3-10 Removing and Replacing Memory Modules
1 DIMM slots (twelve) 2 DIMM slot ejector lever (two on each slot)
3 Alignment key in DIMM slot
1
195728
2
3