Specifications

Send document comments to [e-mail]
3-14
Cisco UCS C200 Server Installation and Service Guide
OL-20732-02
Chapter 3 Maintaining the Server
Installing or Replacing Components
f. Remove the three screws that hold the battery unit bracket to the fan tray and then remove the battery
unit bracket to provide clearance to the cable harness (see
Figure 3-7).
g. Remove the cable harness from the fan tray connector.
h. Remove the two screws that secure the fan tray to the chassis posts and lift the tray out of the chassis.
Step 2 Install a fan tray:
a. Place the new fan tray into the chassis, aligning the two bracket holes on the fan tray with the chassis
posts.
b. Replace the two screws that secure the tray to the chassis posts.
c. Replace the cable harness to fan tray connector.
d. Replace the battery unit bracket and the three screws that secure it to the fan tray.
Note If you removed an optional LSI BBU from the fan tray, replace it and the three screws that secure
it to the fan tray.
e. Replace the cable cover and the top cover.
f. Replace the server in the rack, replace power cords and any other cables, and then power on the
server by pressing the Power button.
Figure 3-7 Removing and Replacing a Fan Tray
1 Securing screw (one on each end) 2 Fan tray with battery unit bracket
3 Fan tray connector
1
2
3