Troubleshooting guide

Send document comments to [e-mail]
29
Cisco UCS B22 Blade Server Installation and Service Note
OL-27513 -01
Removing a Blade Server Cover
Note You must remove the adapter card to service the modular LOM.
To install a modular LOM card on the blade server, follow these steps:
Step 1 Position the modular LOM’s board connector above the motherboard connector and align the captive
screw to the standoff post on the motherboard.
Step 2 Firmly press the modular LOM’s board connector into the motherboard connector.
Step 3 Tighten the captive screw.
Tip Removing a modular LOM is the reverse of installing it. You may find it helpful when removing the
connector from the motherboard to gently rock the board along the length of the connector until it
loosens.
Figure 18 Installing a Modular LOM
1
2
3
332218