Troubleshooting guide

Send document comments to [e-mail]
14
Cisco UCS B22 Blade Server Installation and Service Note
OL-27513 -01
Secure Digital (SD) Card Access
Step 4 Press the ejector lever so that it catches the edge of the chassis and presses the blade server all the way in.
Step 5 Tighten the captive screw on the front of the blade to no more than 3 in-lbs. Tightening with bare fingers
only is unlikely to lead to stripped or damaged captive screws.
Step 6 Power on the server. UCS Manager will automatically re acknowledge, reassociate, and recommission
the server, provided any hardware changes are allowed by the service profile.
Secure Digital (SD) Card Access
SD card slots are provided for future usage. Their use is not supported at product release. They will
require a future software update to be used.
Figure 6 SD Card Slot Locations
Removing a Blade Server Cover
Replacing the cover is the reverse of removing the cover. To open a blade server:
Step 1 Press and hold the button down as shown in Figure 7
Step 2 While holding the back end of the cover, pull the cover up and back.
332219