Troubleshooting guide

Send document comments to [e-mail]
13
Cisco UCS B22 Blade Server Installation and Service Note
OL-27513 -01
Removing and Installing a UCS B22 Blade Server
Step 3 Slide the blade part of the way out of the chassis, and place your other hand under the blade to support
its weight.
Step 4 Once removed, place the blade on an antistatic mat or antistatic foam if you are not immediately
reinstalling it into another slot.
Step 5 If the slot is to remain empty, install a blank faceplate (N20-CBLKB1) to keep dust out of the chassis.
Installing a Cisco UCS B22 Blade Server
Figure 5 shows the positioning of a blade server in the chassis. Blade servers reside within the eight
upper slots of the chassis. To install a blade server, follow these steps:
Step 1 Grasp the front of the blade server and place your other hand under the blade to support it. See Figure 5.
Figure 5 Positioning a Blade Server in the Chassis
Step 2
Open the ejector lever in the front of the blade server.
Step 3 Gently slide the blade into the opening until you cannot push it any farther.
331364