Troubleshooting guide

35
Cisco UCS B200 M3 Blade Server Installation and Service Note
OL-26624-01
Server Troubleshooting
Step 4 On the Advanced tab, select Trusted Computing and press Enter.
Step 5 Set the TPM Support optionto Enable.
Step 6 Press F10 to save and exit. Allow the server to finish booting.
Server Troubleshooting
For general server troubleshooting information, refer to the "Troubleshooting Server Hardware" chapter
of the Cisco UCS Troubleshooting Guide.
Server Configuration
UCS servers are intended to be configured and managed using UCS Manager. Refer to the UCS Manager
Configuration Guide appropriate for your UCS Manager version.
Server Specifications
Related Documentation
The documentation set for the Cisco Unified Computing System environment is described in full at:
http://www.cisco.com/go/unifiedcomputing/b-series-doc
For specifics on which components are supported refer to the server's Technical Specifications ordering
guide at the following link:
http://www.cisco.com/en/US/products/ps10493/products_data_sheets_list.html
Table 3 Physical Specifications for the Cisco UCS B200 M3 Blade Server
Specification Value
Height 1.95 inches (50 mm)
Width 8.00 inches (203 mm)
Depth 24.4 inches (620 mm)
Weight 15.0 lbs (6.8 kg)
1
1. The system weight listed here is an estimate for a fully configured system and will vary depending on peripheral devices
installed.